Transportation, Storage And Disposal - Husqvarna BMG 555 Bedienungsanweisung

Error code
pHF (only operates
with the drive on
load.)
uSF
Transportation
WARNING:
transportation. The product is heavy and can
cause injury or damage if it falls or moves
during transportation.
The wheels let you move the product for shorter
distances.
For longer distances, lift the product to move it or put the
product on a vehicle.
• Make sure that the product is in transport position
during transportation. Refer to
transport position on page 56 .
• Be very careful when you move the product
manually or on surfaces with a slope. Small slopes
can result in a strong movement that is not possible
to brake by hand.
• Put some type of protection on the product
during transportation. The protection keeps natural
elements such as rain and snow away from the
product.
To move the product up and down a
ramp
WARNING:
move the product up and down ramps with
the motor on. The product is heavy and
there is a risk of injury if the product falls
or moves too quickly.
WARNING:
slope, always use a winch. Do not stay
below or near the product.
1806 - 002 - 14.04.2022
Cause
The power for the product is not correct or a
fuse has blown.
1 phase is defective.
3-phase ATV71 is used on a 1-phase power
supply.
The load is defective.
The power supply is too low.
The pre-charge resistor is damaged.
The voltage is not constant.

Transportation, storage and disposal

Be careful during
To set the product in
Be very careful when you
For ramps with a steep
Solution
Refer to the operator's manual for the CAN-
open
Use a 3-phase mains supply.
Do a check of the voltage.
Replace the pre-charge resistor.
Do a check of the product, repair if necessa-
ry.
WARNING:
on steep slopes. Look at the rating plate
on the product for information about the
maximum slope angle.
• To move the product down a ramp, operate the
product rearward slowly.
• To move the product up a ramp, operate the product
forward slowly.
• Do not turn the product more than 45° on a ramp.
To lift the product
WARNING:
equipment has the correct specification to
lift the product safely. The type plate on the
product shows the product weight.
WARNING:
or near a lifted product. Keep bystanders
away from the work area.
WARNING:
product. Make sure that the lifting eyes are
correctly installed and not damaged.
Do not move the product
Make sure that the lifting
Do not walk or stay below
Do not lift a damaged
55