Herunterladen Inhalt Inhalt Diese Seite drucken

Husqvarna BMG 555 Bedienungsanweisung Seite 42

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

1. Pull the lock lever in the direction of the handlebar
and hold it in this position.
2. Adjust the handlebar to an applicable operation
height.
3. Release the lock lever to lock the handlebar position
To change the position of the wheels
The wheels can have 2 positions in the frame. The top
hole (A) is used during standard grinding and polishing
operation. The top hole is also used for the accessories
PCD (Poly Crystalline Diamond) or bush hammer tools.
The lowest hole (B) is used for the accessory star wheel
cutter.
1. Remove the bolts, the washers and the wheel from
the frame.
2. Install in the opposite sequence in the correct hole in
the frame.
42
3. Do the same procedure on the opposite side of the
product.
Operation speed
If the product is operated on a new surface type, set
the speed to 70% initially. When the operator knows the
surface type, the speed can be adjusted.
To start the product, control panel
without speed adjustment
CAUTION:
time while you operate the product. If you
do not move the product, the surface can
become rough.
1. Start the dust extractor.
2. Connect the dust extractor hose to the product.
Refer to
3. Make sure that the electrical enclosure is closed.
4. Connect the product to a power source. Refer to
connect the product to a power source on page 41 .
5. Stay behind the product and hold the handlebar with
your hands.
6. Attach the cord (A) of the operator presence control
on to your arm or to your clothing.
C
B
E
D
7. Do a check of the error indicator (B) to make sure
that there is no error.
8. Turn the emergency stop button (C) clockwise
to make sure that the emergency stop button is
disengaged.
9. Turn the switch for direction of rotation for the motor
(D) right or left.
10. Push the start button (E).
To start the product, control panel with
A
speed adjustment
B
CAUTION:
time while you operate the product. If you
do not move the product, the surface can
become rough.
1. Start the dust extractor.
Move the product all the
To connect a dust extractor on page 41 .
A
Move the product all the
1806 - 002 - 14.04.2022
To

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis