Husqvarna BMG 555 Bedienungsanweisung Seite 40

Diamond tools
There are many different types and configurations of
diamond tools for the product. Metal bonded diamond
tools are used for removal of material and resin bonded
diamond tools are used to polish surfaces. Select the
correct diamond tools for the surface. Speak to your
Husqvarna dealer or go to www.husqvarnacp.com for
support to select the correct tool.
Disc holder alternatives for diamond tools
• Use a Metal bond disc holder to attach metal bonded
diamond tools.
• Use a resin disc holder to attach plastic bonded
diamond tools.
Full set and half set of diamond tools
The configuration of the diamond tool segments has
an effect on the end quality of the surface. The
configuration also has an effect on the operation rate
of the product.
• Full set of diamond tools: This configuration is
applicable for a flat floor finish.
• Half set of diamond tools: This configuration is
applicable when a flat floor finish is not necessary.
To replace the diamond tools
WARNING:
power plug before you replace the diamond
tools, to prevent accidental start.
40
Always disconnect the
WARNING:
diamond tools can become very hot.
WARNING:
protection when you replace the diamond
tools. The dust below the grinding head is
dangerous to your health.
WARNING:
when you replace the diamond tools. The
dust extractor will decrease the dust that can
cause health problems.
CAUTION:
always have the same number and type of
diamond tool segments. The height of the
diamond tool segments must be the same
on all diamond tools.
1. Stop the product and disconnect the power plug.
To stop the product, control panel without
Refer to
speed adjustment on page 44 .
2. Adjust the handlebar to upright position. Refer to
adjust the height of the handlebar on page 41 .
3. Hold the handlebar and tilt the product rearward. Tilt
the product until the support bracket is on the floor.
CAUTION:
power cord and the dust hose do not
become damaged when you tilt the
product.
CAUTION:
thin wood below the support bracket to
prevent damage to the floor.
Use protective gloves, as
Use approved respiratory
Use the dust extractor
All the diamond tools must
Make sure that the
Put a piece of cloth or
1806 - 002 - 14.04.2022
To