Changing The Diamonds; Transport And Storage - Husqvarna PG450 Bedienungsanweisung

Changing the diamonds

Shut down the machine and disconnect the power plug.
Have a set of gloves ready, as diamond tools can get very
hot.
• Put the machine into service position.
• Pull back on handle to lift grinding head off the ground.
• Lay machine back on the ground.
• Put on gloves.
• Use a hammer to remove the diamond segments.
• Affix new diamond segments on the grinding disc.
• Once new diamond segments have been attached,
reverse procedure to lower machine to ground.

Transport and storage

• Secure the equipment during transportation in order
to avoid transport damage and accidents.
• The machine should be transported under cover
where possible, limiting the exposed to natural
elements – in particular rain and snow.
• Store the equipment in a lockable area so that it is out
of reach of children and unauthorized persons.
14 – English
OPERATING
• The machine should always be stored in a dry place
when not in use.
Transport
The machine can be taken apart and folded to give a
smaller size when transporting.
• Disconnect the motor cable from the electrical box.
• Remove the locking pins and then the bolts on each
side.
• Loosen the grinding head from the wheel chassis.
• Put the machine in inclined transport position. Loosen
the locking knobs on the support foot.
• Fold back the support foot.
1
3
2