Husqvarna BMG 555 Bedienungsanweisung Seite 44

Main menu Description
"DRI" Operation menu with operation pa-
rameters and settings.
"Identification" Operation information, type and soft-
ware version.
"Interface" Settings for the display language and
access level.
"TRA" Store and load the configuration on
the keypad.
"Password" To unlock the keypad.
The up and down arrow on the keypad (C) let you to
move up and down the menu lists. The OK button (B)
makes the selection. The back arrow on the keypad (C)
lets you go back in the menu system.
Note:
The display texts in this manual are in English.
The display texts on your product are in the selected
To change the language for the
language. Refer to
display texts on page 44 .
To do a check of operation time
1. Select "DRI" in the main menu.
2. Select "Display".
3. Select "Power-On time" and do one of the
procedures that follow.
a) Select "APH" to show energy consumption.
b) Select "Motor Run Time" to show the time that
the motor has been switched on.
c) Select "Power-on time" to show the time that the
product has been switched on.
d) Select "Time Counter Reset" to reset 1 of the 3
above values.
To do a check of error history
1. Select "DRI" in the main menu.
2. Select "Display".
3. Select "DGT".
4. Select "Error history". The last 10 errors are shown.
5. Select 1 of the errors for more information such as
operation mode, motor current and DC bus voltage.
To change the language for the display texts
1. Select "Interface" in the main menu.
2. Select "language" and select the language for the
display texts.
To control the operation direction
During operation, the product can pull to the sides. The
direction of the pull is related to the direction of rotation
of the grinding head and how the product is operated.
44
• Always keep the 2 wheels on the ground during
operation of the product.
• Apply the side forces on the handle to steer the
product.
• Always hold the handle tightly with 2 hands to stay
stable and make sure that the product does not
move laterally.
To stop the product, control panel
without speed adjustment
CAUTION:
from the surface when you stop the motor.
The tool plates rotate for a while after the
motor stops. Dust can go into the air and the
surface can become damaged.
CAUTION:
become stationary until the tool plates stop
fully.
1. Push the emergency stop button (A).
A
2. Keep the tool plates against the surface until they
stop fully.
3. Remove the key (B) of the operator presence control
from the product.
4. Disconnect the power plug.
5. Stop the dust extractor.
To stop the product, control panel with
speed adjustment
CAUTION:
from the surface when you stop the motor.
The tool plates rotate for a while after the
motor stops. Dust can go into the air and the
surface can become damaged.
CAUTION:
become stationary until the tool plates stop
fully.
Do not lift the grinding head
Do not let the product
B
Do not lift the grinding head
Do not let the product
1806 - 002 - 14.04.2022