Transportation, Storage And Disposal - Husqvarna BMG 780 Bedienungsanweisung

Problem
The internal circuit
breaker releases.
The product stops
again when you start
it.
There is no control
voltage.
The product does not
start when the start
button is pushed on
the control panel or
the keypad.
There is an error in
the display of the
keypad.
The remote control
control and the prod-
uct has no connec-
tion.
The remote control
stops.
Transportation
WARNING:
transportation. The product is heavy and can
cause injury or damage if it falls or moves
during transportation.
24
Cause
Too high a load or not sufficient power sup-
ply.
The emergency stop button is engaged.
The operator presence control is engaged.
There is an error or "RDY" is not shown in
the display.
The remote control is tilted too much.
Too much distance between the remote con-
trol and receiver on the product.
The battery terminals on the remote control
battery or the battery terminals in the remote
control are dirty.
The automatic stop function is in operation.

Transportation, storage and disposal

Be careful during
Solution
Do a check of the power supply.
Decrease the grinding pressure, increase the
number of diamond tools or increase the
bond hardness.
Speak to an approved service center.
Turn the emergency stop button clockwise to
disengage.
If the relay for the emergency stop button
has 3 green LED, the circuit is closed. Reset
the circuit breakers when they are off.
Install the key for the operator presence con-
trol.
Do a check of the error messages on the
display. If "STO" or "PWR" shows in the dis-
play, there is no 24 Vdc to these inputs. Do
a check of the circuit of the emergency stop
button.
In the submenu "Error history", Push the
"Help" button for possible solution. If the sol-
ution is not possible to do, restart the prod-
To do a check of error history
uct. Refer to
on page 19 .
Keep the remote control in horizontal position
during operation.
Stay near to the product.
Clean the battery terminals.
On the rear side of the remote control, push
the enter button for 2 seconds. Set the func-
tion "Auto-off" to "Off". Push the arrow button
on the rear side of the remote control 5 times
to go to "Exit".
The wheels let you move the product for shorter
distances.
For longer distances, lift the product to move it or put the
product on a vehicle.
• Make sure that the product is in transport position
during transportation. Refer to
transport position on page 27 .
To set the product in
1811 - 001 - 02.05.2022