Transportation, Storage And Disposal - Husqvarna CG 200 Bedienungsanweisung

PROBLEMS
Motor or drum does
not rotate
Difficult to start
Ineffective operation
with jerks and consid-
erable vibration
Transportation
Consider the following points when transporting the
product.
• The height of the steering shaft can be adjusted by
rotating the knob (1).
12
CAUSES
Not plugged in properly or cable
damaged
No main voltage
Switch defective, motor cable
damaged
Motor faulty (no power, unpleas-
ant smell)
Does not start (petrol engine)
Belt broken
Drum stuck
Drum rubs against ground
Motor start capacitor
Drum position too low
Tools worn out
Groove or mill makes abnormal
vibration
Abnormal cutter wear

Transportation, storage and disposal

REMEDIES
Make sure that the supply is correctly plugged in (plug,
extension lead, etc). Check the supply cable.
Test or have tested by an electrician (circuit breaker,
plug, etc).
Have tested by an electrician or contact the service de-
partment.
Contact the service department to have the motor re-
placed.
Refer to engine service instructions or contact after sales
service if the engine stopped or find the spark plug faulty
or loose.
Contact the parts department for a replacement.
Ensure the product is disconnected from the power.
Check that the drum rotates, remove whatever prevents
the rotation.
Free the drum to make it easier to start.
Replace the capacitor.
Check the drum (mills) fixture. Change the drum or the
cutters, brush, and so on.
Check the rotation of the cutters on the four shafts.
Change the drum or the cutters.
• Upon installation at the work site, the product can be
moved without running the engine simply by pushing
it along on its three wheels.
130 - 003 - 18.08.2017