First Use; Fill Mode; Use Of The Machine; Preparation Of The Machine - Profitec GO Bedienungsanleitung

5

FIRST USE

Read the instruction manual carefully prior to operating the machine.
Prior to starting the machine, check if:
• the steam valve is closed.
• the switch and buttons are not activated.
• the power cord is disconnected.
• the drip tray is inserted correctly.
• the machine is placed on a water resistant surface.
Now you can begin to operate your machine:
1 Remove the water tank lid.
2 Fill the water tank with fresh water, preferably low in lime. Replace the water tank lid.
3 Insert the power plug into the wall socket and press the power-switch. The machine is now on.
Important!
For the initial set-up the boiler has to be filled, by pressing the switch for coffee.

Fill Mode

When using the machine for the first time, it will be in fill mode, with "FIL" displayed on the PID. Place a
small container (e. g. a. milk jug) under the brew group. Press the coffee button and the pump will begin
to fill the boiler and the shot counter will begin. Wait until the shot counter has reached at least 30 and
water is being dispensed from the brew group before pressing the coffee button again to stop filling the
boiler. The PID display will now show UP and the boiler temperature will appear after a short time.
4 As soon as the optimum temperature is reached, the heating shuts off automatically. The indicator of
the pump pressure gauge may move slightly during the heat-up phase.
5 Clamp the empty portafilter into the brew group to preheat the filter and the portafilter. You can
accelerate this process by dispensing water from the brew group.
6 The machine is now ready for use. Place the cups on the cup heating tray to preheat them.
Before preparing the first coffee, please rinse the machine by extracting about 2-3 water
tank fillings.
Please note that the portafilter, drip tray and water tank are not dishwasher safe.
6

USE OF THE MACHINE

6.1 Preparation of the machine

The switched off machine is to be placed into operation as follows:
1 Ensure that there is sufficient water in the water tank.
2 Ensure that the switches are in the off position and the steam valve is closed.
3 Turn the machine on (push the power switch).
4 The heating period depends on the ambient temperature and is approx. 4 minutes. The indicator of
the pump pressure gauge may move slightly during this time. UP is shown on the display, which
means "Heat up Phase".
5 Once the machine reaches its set temperature, it is ready for use.
6 Insert the portafilter, activate the coffee button and dispense some hot water. This way, the portafilter
will be preheated.
It is recommended to leave the portafilter in the brew group, keeping it warm for optimal
coffee dispension temperature.
Translation of the original German user manual
ENGLISH
24