Adjusting The Operating Mode Of The Rs232 Interface - G&D VisionXS-F-DP-UHR Installation Und Bedienung

Configuration

Adjusting the operating mode of the RS232 interface

In the default setting of the extender, you can connect any RS232-compatible device
to the optional RS232 interface of the console module. The RS232 data stream is
transmitted unchanged to the computer module.
For transmitting RS422 signals, you can use two
adapters converts the RS232 interface of the console module and the computer mod-
ule into interfaces.
RS422
IMPORTANT:
If you want to transmit
you also need to change the operating mode of the RS232 interfaces of both the
console and the computer module.
How to set the operating mode of the RS232 interface:
1. Press
Ctrl+Num
2. Select the row
operating mode of the RS232 interface of the console module (
Select the row
operating mode of the RS232 interface of the computer module (
3. Under
RS232 port mode
RS232  The data stream of an RS232 device is transmitted from the
computer module to the console module (default).
 The data stream of an RS422 device is transmitted from the
RS422
computer module to the console module via separately
available
4. Press to save your settings.
F2
39 · G&D VisionXS-F-DP-UHR
RS422
(default) to open the on-screen display.
Console setup and press
Target setup and press
press to select on of the following options:
F8
G&D RS232-422 adapters
G&D RS232-422 adapters
signals, in addition to using adapters,
Enter if you want to adjust the
Enter if you want to adjust the
.
. Each of the
).
CON
CPU ).