G&D VisionXS-F-DP-UHR Installation Und Bedienung Seite 95

Establishing a connection to the user module
Transmission 1 Transmission 2 Transmission 2 Service Service
IMPORTANT:
The devices use components with laser technology which comply
with laser class 1.
Never stare directly into the beam when wearing optical instruments!
NOTE: Remove the protection caps from the Transmission interfaces and from the
cable plug.
Insert the LC plug of a fibre optic cable, which is available as
Transmission 1|Tx:
accessory, into this interface. Connect the other end to the Transmission|Rx interface
of the user module or to one of the Dynamic Ports of a compatible matrix (see page 5).
Transmission 1|Rx: Insert the LC plug of a fibre optic cable, which is available as
accessory, into this interface. Connect the other end to the Transmission|Tx interface
of the user module or to one of the Dynamic Ports of a compatible matrix (see page 5).
NOTE:
The activation of the
interface.
To use the Transmission 2
Choose the right SFP transceiver
The
Transm. Redundancy modules
the Transm. Redundancy feature
Use the Transmission 2
part.
Network Network Pwr Main Power Pwr Main Power
Transm. Redundancy feature
interface, you need an additional SFP transceiver.
for your variant of the
contain both, a corresponding
.
interface to establish a connection with a second counter-
Red. Power Red. Power
activates the
VisionXS-F-DP-UHR
SFP transceiver
G&D VisionXS-F-DP-UHR · 10
Installation
Transmission 2
series.
and