How To Measure With Cursors - PeakTech 1280 Bedienungsanleitung

12. How to Measure with Cursors

to show Function menu, choose "Mark Cursor".
Click
12.1. Normal mode
1. Choose source: choose the channel to be measured by cursors between CH1 and CH2.
2. Check measurement type: choose either Time cursor measurement or Voltage cursor
measurement, or both.
12.2. Time cursor measurement
Tick on "Time" option, then two light red lines display along the vertical direction of the screen, which
represent Cursor 1 and Cursor 2.
Place the mouse pointer over Cursor 1 or Cursor 2, drag after the mouse pointer changing to ,
adjust the positions of Cursor 1 and Cursor 2 according to the waveform to be measured. The cursor
increment window at the left bottom shows current time of the two cursors, absolute time difference of
the two cursors and frequency. (See figure below)
-82-