PeakTech 1280 Bedienungsanleitung Seite 62

Appendix B: General Care and Cleaning
General Care
To avoid any damage to the instrument or probe, do not exposed it to any sprays, liquids, or solvents.
Cleaning
Inspect the instrument and probes as often as operating conditions require. To clean the instrument
exterior, perform the following steps:
Wipe the dust from the instrument and probe surface with a soft cloth.
Disconnect the USB cable before cleaning your Oscilloscope. Clean the instrument with a wet soft
cloth not dripping water. It is recommended to scrub with soft detergent or fresh water. To avoid
damage to the instrument or probe, do not use any corrosive chemical cleaning agent.
Warning:
Before power on again for operation, it is required to confirm that the instrument has already been
dried completely, avoiding any electrical short circuit or bodily injury resulting from the moisture.
®
6. PeakTech Oscilloscopes Software Help
Minimum PC Requirements
Processor: Pentium(R) 4 2.4 GHz
Memory: 1 GB
Disk space: 1 GB minimum
Recommended PC Requirements
Processor: Pentium(R) Dual-Core 2.4 GHz
Memory: 2 GB
Disk space: 1 GB minimum
Other Requirements
Operating system: Windows XP (32-bit & 64-bit), Windows Vista (32-bit & 64-bit), Windows7 (32-bit &
64-bit), Windows 8 (32-bit & 64-bit)
Ports: USB 2.0
Display Resolution: 1024 x 76
PC Software USB Driver Install Guide
Use the supplied USB cable to connect the oscilloscope with a PC through their USB ports.
Note: If you use a U SB cable that is not supplied by us, some problems such as connection error and
signal disturbing might occur.
-61-