PeakTech 1280 Bedienungsanleitung Seite 96

Network
The oscilloscope could be connected to a PC via LAN port. For more details, see
Tips Window
Choose a label among "Channel", "Capture&Period" or "Trigger" to view the guide for the new users.
Click anywhere in the help window to turn page.
If you do not want to display the guide automatically when running the software, check "Don't show
again".
About
Display Version, Serial Number and Company website.
SyncTrigger
Control the function of the port 5 in Ports of the Oscilloscope.
Trigger In: Input the trigger signal synchronously
Trigger Out: Output the trigger signal synchronously
Pass/Fail: Output high level when pass, output low level when fail.
20. How to Use Executive Buttons
Executive Buttons include Auto Set
Interface.
AutoSet:
It's a very useful and quick way to apply a set of pre set functions to the incoming signal, and display
the best possible viewing waveform of the signal and also works out some measurements for user as
well.
The details of functions applied to the signal when using AutoSet are shown as the following table:
Function items
Acquisation Mode
Vertical Coupling
Vertical Scale
Horizontal Level
Horizontal Scale
Trigger Type
Trigger Source
Trigger Coupling
Trigger Slope
Trigger Level
Trigger Mode
Display Format
Run/Stop:
Single Trigger:
Keyboard Shortcuts
Enter: Auto set
Space: Run/Stop
, Run/Stop
Setting
Current
DC
Adjust to the proper division
Middle
Adjust to the proper division
Current
Show the minimum number of channels
Current
Current
Mid-point Setting
Edge
YT
Enable or disable sampling on input signals.
You can set the trigger mode as single directly, so when trigger occurs,
acquire one waveform then stop.
/ , Single Trigger
-95-
21. Use LAN Port.
. See 7, 8, 9 in 7.User