PeakTech 1280 Bedienungsanleitung Seite 73

Space: Run/Stop
Enter: Auto set
Q: The voltage division of Channel 1 decreases one
A: The voltage division of Channel 1 increases one
W: The voltage division of Channel 2 decreases one
Instruction of the status information
Auto
Ready
S: The voltage division of Channel 2 increases one level
Trig'd
←: Time base decreases one level
Scan
Stop
→: Time base increases one level
Error
ReSyncing
AutoSet
F1: Open this help document
The statuses of not staying connected with the oscilloscope:
Offline
USBFound
USBDrvErr
MachineNotSupport
The statuses in the process of connecting with the oscilloscope:
Linking
Connect
Match
Syncing
Keyboard Shortcuts
level
level
level
Automatic trigger mode
Ready for a tri g ger
Has trigged
Slow scan
Data acquisition stopped
Error occurred
Synchronize with the oscilloscope again
In process of auto setting
No connection with the oscilloscope
Find available USB devices
USB drivers installed error
Can not recognize the device
Being connecting with the oscilloscope
connect successfully
Matching the model
Sync the settings
-72-