Initial Operation; Selection Of Power Rating - clage DEX Next S Gebrauchs- Und Montageanleitung

8. Initial operation

STB
Multiple Power System MPS
®
The rated capacity (max. power con-
sumption) is 27 kW / 400 V and can be
changed internally to 24 kW, 21 kW or
18 kW.
Before making the electrical connection, fill the mains and the appliance with water
by carefully opening and closing the hot water tap in order to vent completely.
To ensure a maximum flow, remove any existing aerator from the faucet. Flush the
warm and cold water pipes each at least for one minute.
After every draining (e.g. after work on the plumbing system or following repairs to
SDB
the appliance), the heater must be re-vented in this way before starting it up again.
If the water heater cannot be put into operation, the temperature cut-out or the pres-
sure cut-out may have tripped during transport. If necessary, check that the power
supply is switched off and reset the cut-out.

Selection of power rating

Only by authorised specialist, otherwise lapse of guarantee!
On delivery, the display shows the screen "APPROVED" (see left). If not, the device
has already been powered once. In this case, please follow the section "Reinstallation".
Upon first connection of the appliance to the supply voltage, select the maximum
power rating. Only after having set the power rating, the heater provides its standard
operation mode.
The maximum allowable power rating at installation site depends on the local situa-
tion. It is imperative to observe all data shown in the table "Technical specifications",
in particular the required cable size and fuse protection for the electrical connection.
Moreover, the electrical installation must comply with the statutory regulations of the
respective country and those of the local electricity supply company (Germany: DIN
VDE 0100).
1. Switch on the power supply to the appliance.
2. When switching on the supply voltage for the first time, the display shows the menu
to select the language. Choose your language, after that the selection of power rat-
ing appears.
3. Select the maximum allowable power rating depending on the local situation via
sensor keys (18, 21, 24 or 27 kW).
4. Select "OK" to confirm the setting.
5. Mark the set power rating on the rating plate.
6. After having set the maximum allowable power rating, the heating element will be
activated after approx. 10 – 30 sec of continuous water flow.
7. Open the hot water tap. Check the function of the appliance.
8. Start up the FX3 remote control according to steps 2-6 in chapter "3. Remote con-
trol" section "Connecting the remote control to the instantaneous water heater"
®
(see page 36).
9. Explain the user how to use the instan ta neous water heater and hand over the oper-
ating instructions.
10. Fill in the guarantee registration card and send it to the CLAGE After-Sales Service
:
or use the online regis tration on our website (see also page 28).
51
CLAGE
EN