clage DEX Next S Gebrauchs- Und Montageanleitung Seite 33

2. How to use
Value Description
Operation without load shedding
0
relay, factory setting
Operation with normal
1
load shedding relay
Operation with sensitive
2
load shedding relay
• Settings: Automatically active as soon as a password has been generated. Users can
only access the settings menu with a PIN.
• All: PIN entry is required to operate the appliance.
• OFF: The PIN is deleted and the appliance can be operated freely.
Electricity price (currency/kWh): Specify the electricity price of your own electricity
supplier.
Water price (currency/m³): Specify the water price of your own water supplier.
Load Shedding: If further three-phase appliances are connected, a load shedding relay
designed for electronic instantaneous water heaters (CLAGE no. 82250) can be con-
nected to phase conductor L2. This relay ensures the operation of the water heater by
switching off other consumers until the end of heating operation.
Select "OK" to activate the edit mode. To set a value of "0", "1" or "2" press and hold
or for two seconds.
Operating mode 1 must be selected first, thus to check the correct operation of the
load shedding relay at low appliance output (35 degree celsius setpoint and low water
flow rate). Mode 2 must be selected if the load shedding relay flickers.
Factory Settings: All factory settings can be recalled. Temperature limit for showering
and load shedding are not affected.
Note: All customised user profiles and power and water prices entered, are deleted.
Delete Statistics: Use this function to delete all previously collected statistical data.
Deleted statistical data cannot be restored.
Thermal treatment: With this function, you can support a thermal treatment of your
appliance and the following pipeline, including the tap. A thermal disinfection accord-
ing to the accepted rules of technology is not replaced.
• Tap "OK" to start the treatment cycle and the outlet temperature is set to 70 °C.
The function is disabled if the appliance is connected to a shower.
• Draw hot water for at least three minutes to heat the pipes to the tap completely.
• A change of the temperature or 30 sec without water flow terminates the treat-
ment cycle.
• The number as well as the accumulated duration and the water amount of all ther-
mal treatments will be saved.
Notes:
Ensure that no one can be injured by the elevated temperatures and that the installa-
tion can withstand the strain.
The exiting water and the tap become very hot! The water steam should not be
inhaled.
33
CLAGE
EN