Setup - MC Crypt MX 1204FX Bedienungsanleitung

7. Set-Up
When selecting the installation location for your device, avoid direct sunlight, vibration, dust,
hot and cold temperatures and dampness. When setting it up with other equipment, make
sure that the device is well ventilated. Keep a sufficient distance to heat sources. Do not point
any strong spotlights or light sources towards the device. This may lead to overheating (risk
of fire!).
Heat dissipation from the device must not be obstructed. Never place the device on soft sur-
faces such as a carpet or a bed. Air circulation must not be obstructed by objects such as
magazines, table cloths, curtains or similar. This prevents heat dissipation from the device
and can lead to overheating (risk of fire!).
Only operate the device on a sturdy surface that is not sensitive to high temperatures.
Make sure that the device is set up securely positioned on a steady surface. Persons can be
injured if the device falls down.
The device must not be set up in the vicinity of other devices with strong electric or magnetic
fields, such as transformers, motors, wireless phones, radio devices, etc. since they might
interfere with the device. Keep as great a distance as possible to such devices.
Do not drill any holes or screw any additional screws into the device's housing, since this
could cause contact to dangerous voltages.
Make sure that the connection cables are not squeezed or damaged by sharp edges. Always
install the cables so that no one will trip over them or get caught in them. Risk of injury!
The cables must be of sufficient length. Avoid mechanical strain on the cables. This may
damage the cables or the device. There is the risk of a fatal electric shock.
Due to the great variety of varnishes and polishes of furniture, the device feet might leave
visible marks on the furniture caused by chemical reactions. Therefore, the device should not
be placed on valuable furniture surfaces without suitable protection.
44