Tape Input / Tape Output - MC Crypt MX 1204FX Bedienungsanleitung

6. Connections and Control Elements
3) STEREO AUX RETURN 1 control
With the STEREO AUX RETURN 1 control, the input level of the STEREO AUX
RETURN 1 signal (L/R) is adjusted. The signal is mixed on the MAIN MIX bus.
4) STEREO AUX RETURN MON control
Use the STEREO AUX RETURN MON control to mix an effect signal for the monitor
signal.
The following terminal points are necessary:
AUX SEND 2 socket: Connection L (MONO) input of the external effect device
STEREO AUX RETURN 1 sockets: Connection of the output of the external effect device
AUX SEND 1 socket: Connection of the monitor amplifier
The AUX SEND 1 MASTER control sets the level at the monitor signal output. The STEREO AUX RETURN MON
control sets the level at the effect signal for the monitor signal.
5) STEREO AUX RETURN 2 (FX)
With the STEREO AUX RETURN 2 (FX) control, the input level of the STEREO AUX RETURN 2 signal (L/R) is
adjusted. The signal is mixed on the MAIN MIX bus.
If the STEREO AUX RETURN 2 sockets are not used, this control sets the overall level for the effect signal of the
internal digital effect processor (DSP). This signal is mixed on the MAIN MIX bus.
6) MAIN MIX/ALT 3-4
Use the MAIN MIX/ALT 3-4 switch to send the STEREO AUX RETURN 2 signal to the ALT 3-4 or MAIN MIX bus.
Switch not pressed = MAIN MIX Bus
Switch pressed = ALT 3-4 Bus

TAPE INPUT / TAPE OUTPUT

1) 2-TRACK INPUT
The 2-TRACK INPUT sockets are mainly used for connecting the outputs of a recording
device (e.g. CD recorder). This input can also be used as an additional STEREO LINE
input, e.g. for connecting a CD player.
If the SOURCE SELECTON (RECORD) output of an amplifier is connected,
you can listen to the devices connected to the amplifier (e.g. CD player,
tuner, etc.) with the SOURCE SELECTION switch.
To send the 2-TRACK INPUT signal to the MAIN MIX bus, the 2TK TO
MAIN MIX switch must be pressed.
3
TO AUX
SEND 1