Write Io-Link Parameters - Balluff BNI EIP-508-105-Z067 Konfigurationsanleitung

BNI EIP-508-105-Z067
Network interface
3
Configuration via Explicit Messages (continued)
3.5.2

Write IO-Link parameters

Service code Class
0x32 0x96
n: Number of ports
1)
Tab. 3-7: Values for write IO-Link parameters
1. Select Source Element and Destination Element as
described in the example Read IO-Link parameters on
page 14.
The Source Length must be the same length as the
parameter data to be written. In this example the
index 0x4E, subindex 0, value 0x02 are written in the
Source Element Array (Write).
In the event of a parameterization error an error code is
displayed in the Destination Element Array (Read).
Fig. 3-6: Configuration
2. In the c tab select the Ethernet module for
OMMunicatiOn
which parameters should be set.
Fig. 3-7: Select Ethernet module
The Explicit Messages functions are implemented
according to Volume 1: Common Industrial
Protocol Specification and Volume 2: Ethernet/IP
Adaption of CIP.
16 english
Instance Attribute
1 – n 0x02
1)
(Write
parameters)