Network Interface; User Instructions For This Guide; Symbols And Conventions; Technical Terms And Abbreviations Used - Balluff BNI EIP-508-105-Z067 Konfigurationsanleitung

BNI EIP-508-105-Z067

Network interface

1

User instructions for this guide

1.1 Validity
This guide describes the integration and configuration of
the following products:
– BNI EIP-508-105-Z067
The configuration guide does not replace the user's guide.
Read the corresponding user's guide and
supporting documents in full before
installing and operating the product.
This guide was created in German. Other language
versions are translations of this guide.
© Copyright 2022, Balluff GmbH
All content is protected by copyright. All rights reserved,
including the right to reproduce, publish, edit and translate
this document.
Disclaimer
The following description is provided free of charge and is
a general application example. The description should
support the programming and planning of PLC
applications and illustrate possible solutions. The user has
no claim to warranty, error correction or updates. In
particular, any claims for compensation that could result
from the use of this description are excluded. This liability
limitation excludes (a) damages due to loss of life, personal
injury or harm to health, (b) liability in accordance with the
Product Liability Act and (c) cases of intent. Prior to
implementation in systems and machines, please check
whether the description provided here is intended for your
application. The use of this free description shall be
deemed to imply acceptance of the warranty and liability
limitation!
www.balluff.com
1.2

Symbols and conventions

Individual action instructions are indicated by a preceding
triangle.
► Instruction 1
Action sequences are numbered consecutively:
1. Instruction 1
2. Instruction 2
Numbers unless otherwise indicated are decimals
(e.g. 23). Hexadecimal numbers are represented with a
preceding 0x (e.g. 0x12AB).
Buttons or selectable menu entries are described in italic
and small caps, e.g. S .
ave
Menu commands are joined with a greater-than sign,
e.g. "S > O " stands for the menu command
ettingS ptiOnS
Options from the Settings menu.
Note, tip
This symbol indicates general notes.
1.3

Technical terms and abbreviations used

I/O Input/Output
EMC Electromagnetic compatibility
EIP EtherNet/IP
FE Functional earth
HW Hardware
IODD IO-Link Device Description
IOL IO-Link
ISDU IO-Link-Parameter (Index Service Data Unit)
n.a. Not available
SIO Standard inputs/outputs
PLC Programmable logic controller
UA Actuator supply
US Sensor supply
1.4

Pictures

The screenshots shown for the configuration are taken
from the Rockwell RSLogix-5000 configuration project
planning software.
english 5