Network Interface - Balluff BNI PNT-508-105-Z067 Montageanleitung

BNI PNT-5_8-105-Z0_7

Network interface

The CE Mark verifies
that our products meet the requirements
of the current EU Directive.
About this guide
This guide provides important information about the
installation and connection of the following Profinet-IO-
Link-Master:
– BNI PNT-508-105-Z067
Order code: BNI00EN
BNI PNT-508-105-Z077
–
Order code: BNI00EP
BNI PNT-538-105-Z067
–
Order code: BNI00EJ
– BNI PNT-538-105-Z077
Order code: BNI00ET
Other applicable documents
A comprehensive user's guide and additional information
about this product can be found at www.balluff.com on
the product page.
Intended use
The Profinet IO-Link master serves as decentralized I/O
and IO-Link Block for connection to a PROFINET fieldbus
and is intended for use in industrial applications.
The module may only be operated with an approved
power supply. Only approved lines may be connected.
Flawless function in accordance with the specifications in
the technical data is ensured only when using suitable
original Balluff accessories. Use of any other components
will void the warranty.
Non-approved use is not permitted and will result in the
loss of warranty and liability claims against the
manufacturer.
Reasonably foreseeable misuse
The product is not intended for the following applications
and areas and may not be used there:
– In safety-oriented applications in which personal safety
depends on the device function
– In explosive atmospheres
6,5
30,5 25
www.balluff.com
224
208,5
M12x1 8(x) M12x1
25 25 M12x1
File
Enclosure rating
Ambient temperature
Safety notes
Activities such as installation, connection and
commissioning may only be carried out by qualified
personnel.
Qualified personnel are persons whose technical
training, knowledge and experience as well as knowledge
of the relevant regulations allow them to assess the work
assigned to them, recognize possible hazards and take
appropriate safety measures.
The operator is responsible for ensuring that local safety
regulations are observed.
In particular, the operator must take steps to ensure that a
defect in the product will not result in hazards to persons
or equipment.
The product must not be opened, modified or changed. If
defects and unresolvable faults occur in the product, take
it out of service and secure against unauthorized use.
The BNI modules generally have good chemical and oil
resistance. When used in aggressive media (e.g.
chemicals, oils, lubricants and coolants) in high
concentrations (e.g. due to low water content), the material
resistance must be checked in advance for the specific
application. In the event of failure or damage to the BNI
modules due to these kinds of aggressive media, claims
for defects are ruled out.
Hot surfaces
The housing heats up under normal operating conditions.
There is a risk of burn injuries. Avoid direct skin contact
with the surface.
Dimensions
M12x1
1,8
M12x1
E319845
Type 1
+45 °C
english 1