Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Page EN-22
Operation: Additional functions
Operation: Additional functions
Start time preselection
The cycle usually starts as soon as you have
pressed the
button (9). This appliance also
offers you the option to delay the start time.
The delay can be 3, 6 or 9 hours.
Setting the start time preselection
1. Select the desired cycle using the cycle
selector (1).
2. Press the "Start time preselection" but-
ton (11) repeatedly until the
with the desired delay lights up.
3. Press the
button (9).
The cycle will start after the delay setting
has elapsed.
Terminate delay
If the
button (9) has
• already been pressed:
switch the appliance off using the
ton (8).
• not yet been pressed:
press the "Start time preselection" but-
ton (11) repeatedly until the
out.
Button lock/Child lock
The button lock allows you to secure the ap-
pliance from unwanted use. This is how you
prevent a cycle in progress from being inter-
rupted by mistake. To
• activate the button lock, simultane-
ously press and hold the two buttons
"Rpm
" (12) and "Start time preselec-
tion" (11) for approx. 3 seconds until the
LED (5) lights up and you hear three
beeps.
All operating controls are locked (excep-
tion:
button (8)).
• deactivate the button lock, simultane-
ously press and hold the two buttons
"Rpm
" (12) and "Start time preselec-
tion" (11) for approx. 3 seconds until the
LED (5) goes out and you hear three
beeps.
Please note! If you have switched off the
beeps, there will be no beeping, even when
you activate/deactivate the button lock.
Switching beeps on/off
You can decide whether or not there should
be a beep when a button is pressed and
when the cycle ends.
LED (4)
• To change the current setting, press the
"Rpm
Automatic control functions
The following functions run automatically. You
cannot change them.
– Foam detection
but-
The electronic foam detection makes sure
that more water is added to the first rinse
cycle for certain amounts of foam.
– Overflow protection system
LED (4) goes
This system prevents water from escaping
via the dispenser. As soon as a certain wa-
ter level is exceeded, the outlet pump will
automatically switch on.
– Dynamic quantity control
If your appliance is only loaded up to a
maximum of half its maximum capacity,
the water consumption and cycle duration
will be reduced for some cycles. Adjust the
detergent dosage accordingly.
The cycle starts as soon as the appliance
has determined the amount of laundry (ap-
prox. 1 minute).
– Imbalance correction system
This system protects your appliance in the
event of a too-great imbalance once spin-
ning starts. This can happen with small
loads or with large individual pieces of
laundry. The laundry is distributed again
and the spin speed increased if the laundry
distribution is right.
" button (12) for 3 seconds.
Werbung
Inhaltsverzeichnis
