hanseatic HTW610D Gebrauchsanleitung Seite 79

System error messages
LEDs
(2) (3)
90 1000
60 800
40 600
20 400
90 1000
60 800
40 600
20 400
90 1000
60 800
40 600
20 400
90 1000
60 800
40 600
20 400
Other problem.
LED flashes, LED is off.
Possible causes
(4)
9 Appliance lid and/
6 or washing drum
3 are not closed.
Water level in the
9
appliance is lower
6
than the heating
3
coil.
9
Pump is faulty or
6
lint trap is clogged.
3
9
Too much water in
6
the appliance.
3
Please contact our Service department (see page EN-38).
Troubleshooting table
Solutions, tips
Close the appliance lid and/or washing
drum properly and restart the cycle.
If the problem persists, please
contact our Service department (see
page EN-38).
– The water pressure, to which the ap-
pliance is connected may be too low
or the valve may be closed. If neces-
sary, open the valve completely.
– If necessary, loosen any twists or
knots in the water inlet hose.
– Clean the filter in the water inlet hose
(see "Checking the water intake filter,
cleaning and replacing the gasket" on
page EN-26).
If the problem persists, please
contact our Service department (see
page EN-38).
Clean lint trap (see page EN-27). If the
problem persists, please contact our
Service department (see page EN-38).
The appliance is automatically
pumping water away. After draining,
switch off the appliance, pull the mains
plug out of the socket and close the
valve. Please contact our Service
department (see page EN-38).
Page EN-37