Cleaning The Dispenser; Checking The Water Intake Filter - hanseatic HTW610D Gebrauchsanleitung

Page EN-26 Care and maintenance

Cleaning the dispenser

1. Fold the appliance lid (14) upwards.
(15)
2. Press the button (24) and remove the dis-
penser (15).
3. Wash out all compartments, wipe down or
brush out thoroughly.
4. On the reverse side, remove the plug for
the fabric softener and bleach compart-
ment and remove all residues. Then re-
place the plug.
5. Re-attach the dispenser (15) to the appli-
ance lid and close the appliance lid.
Checking the water intake
filter, cleaning and replacing
the gasket
NOTICE
Risk of damage to property!
Improper handling of the appliance
may result in damage.
■ Turn off the water intake tap after
(24)
each use, before cleaning the wa-
ter intake fi lter or replacing the gas-
ket. Otherwise there is a risk of water
damage.
■ Close the valve before cleaning the
fi lter or replacing the gaskets.
■ Check and clean fi lters and gaskets
regularly.
■ Replace defect fi lters and gaskets im-
mediately. Never operate the appli-
ance without fi lters and gaskets.
There are filters in the appliance's water inlet
which prevents foreign particles from entering
the appliance.
Check and clean the filter every 3 months or
if the appliance is not getting enough water
despite the tap being open completely.
1. Switch off the appliance, take the mains
plug out of the socket and turn off the tap.
2. Unscrew the water inlet hose from the
valve.
3. Clean the filter with a small brush.
4. Screw the water inlet hose onto the valve
again.