Aligning The Appliance; Water Connection - hanseatic HTW610D Gebrauchsanleitung

– The ground must be secure, even, clean
and dry.
– It is not appropriate to have a rug or car-
pet under the appliance, as the appliance
will not be ventilated well enough and can
overheat.
For use on rugs, carpets, parquet or wood-
en floorboards, place a stable wooden
board (measuring at least 40 × 60 cm) un-
derneath the appliance.
If it is placed on a wooden plate or base,
the screw-on feet should be fixed so that
the appliance does not dislodge itself when
spinning.
Lay a smooth tiled floor or rubber mat un-
der the screw-on feet.

Aligning the appliance

1. Loosen the lock nut (30) of one of the
screw-on feet (20) underneath the appli-
ance.
2. Using your hand, screw the foot (20) in
or out as far as necessary. To adjust the
foot, twist it
– anti-clockwise to unscrew.
– clockwise to screw in.
3. Repeat this for the other screw-on feet
until the appliance is standing completely
horizontally and securely.
4. Twist the lock nuts of all screw-on feet
upwards to the underside of the machine
and tighten the lock nut against the un-
derside of the machine.
Installation, connection and initial commissioning

Water connection

Establish drain for water
Risk of scalding!
Improper handling of the appliance
can lead to scalding caused by hot suds.
■ Fix the hose to the sink or bath to pre-
■ For drains, make sure that the
Risk of damage to property!
Improper handling of the appliance
can lead to water damage.
(30)
■ Use only the water outlet hose pro-
■ Do not extend the water outlet hose
(20)
■ The water outlet hose must not get
■ The curvature of the water outlet
■ The water outlet hose must be in the
WARNING!
vent it from slipping due to the recoil
caused by pumping.
cross-section of the discharge pipe is
great enough that the drain cannot
overfl ow.
NOTICE
vided.
or replace it with another hose.
bent or twisted.
hose must be at least between 60 cm
and 100 cm above the ground to en-
sure the water drain functions per-
fectly.
retaining clips on the back of the ap-
pliance so that the bend on the hose
always remains above the waterline
inside the appliance. The end of the
hose must not be submerged in the
pumped water.
Page EN-31