hanseatic HTW610D Gebrauchsanleitung Seite 49

Risk of injury!
Improper handling of the appliance
may result in injury.
■ The appliance is very heavy. Nev-
er transport or carry the appliance
alone; always with the assistance of
another person.
■ Remove all obstacles on the transport
route and from the installation loca-
tion, e.g. open doors and clear away
objects lying on the fl oor.
■ Take care to prevent any risk of trip-
ping when laying out the mains cord
and hoses.
NOTICE
Risk of damage to property!
Improper transport and installation
may result in damage to the appliance.
■ If a trolley is used to move the ap-
pliance, the appliance must be lifted
as shown on the packaging. Always
transport the appliance vertically.
■ Do not use any sharp or pointed ob-
jects when unpacking the appliance.
■ Do not pull on the appliance lid.
■ Remove all packaging material be-
fore fi rst use.
■ Make sure the appliance is not con-
nected to the power supply whilst the
transport safety devices are being re-
moved or installed.
■ For rugs, carpet, parquet or wooden
fl oorboards, place a stable wooden
plate measuring at least 40 × 60 cm
underneath the appliance.
Do not stand the appliance on rugs or
carpets. Otherwise, it may not be able
to properly ventilate, which can result
in overheating and damage to it.
Safety
■ When positioning on a wooden plate
or base, these must be equipped with
indentations for the screw-on feet so
that the appliance does not migrate
off it when spinning.
■ Do not place the appliance on top of
other appliances and do not use it as
a base for other appliances (e.g. for
dryers).
■ Do not sit or stand on the appliance.
Improper handling of the appliance
can lead to water damage.
■ Do not leave the appliance unsuper-
vised for long periods of time while
the valve is open. When draining
as a result of leakiness, substantial
amounts of water may leak out.
■ Do not connect the appliance to the
cold water supply.
■ Only connect the appliance to a wa-
ter supply with an inlet water pressure
between 0.1 Mpa and 1.0 Mpa (1.0 to
10.0 bar). For higher water pressure,
a pressure regulator needs to be in-
stalled. Enquire about the water pres-
sure with the local waterworks.
■ Close the water inlet tap after every
use.
■ Close the water inlet tap before clean-
ing the water inlet fi lter.
■ Only use the hose set delivered with
the appliance to connect to the water
supply. Do not use old hose sets.
■ Do not extend the water outlet hose
or replace it with another hose.
■ Make sure that the water outlet hose
is not kinked or twisted.
■ Be aware that substantial amounts
of water may leak out during emer-
gency draining.
Page EN-7