hanseatic HTW610D Gebrauchsanleitung Seite 77

Problem
Mains plug is not sitting
properly in the socket or is not
Appliance does not
plugged in.
work.
Socket has no voltage.
Fuse is not intact.
No wash cycle set.
Washing drum and/or
appliance lid are not closed
Wash cycle does
properly.
not start.
Cycle was not started.
The appliance calculates the
amount of laundry (approx.
1 minute).
Valve is closed.
Washing drum and/or
appliance lid are not closed
properly.
Appliance is not There is a kink in the water
receiving water. inlet hose.
The water inlet hose is
clogged.
Filter on inlet is clogged.
Outlet hose is clogged or
Water is not being
kinked.
pumped.
The lint trap is clogged.
Water is draining
even though the
Outlet hose is too low.
appliance is not
pumping.
Inlet or outlet hose is not
Water is running
screwed on tightly enough.
out (appliance is
"leaking").
Lint trap not closed properly.
Malfunction
Possible causes
Troubleshooting table
Solutions, tips
Plug it into the socket properly.
Check fuse; switch on if necessary.
Replace fuse.
Select the desired wash cycle using the
cycle selector (1).
Close the washing drum and/or
appliance lid properly.
Press the button (9).
The program cycle starts as soon as the
appliance has determined the amount of
laundry.
Open valve.
Close the washing drum and/or
appliance lid properly.
Check water inlet hose; dismantle if
necessary and re-align.
Clean the filter on the water inlet hose
(see page EN-26).
Clean the filter on the inlet (see
page EN-26).
Check outlet hose; dismantle if
necessary and re-align.
Clean lint trap (see page EN-27).
Place outlet hose higher.
Screw down inlet or outlet hose down
tighter.
Properly close the lint trap (see
page EN-27).
Page EN-35