Emptying Residual Water - hanseatic HTW610D Gebrauchsanleitung

Page EN-28 Care and maintenance
4. Place a suitable collecting container un-
derneath the lint trap (27).
5. Open the lint trap (27) anticlockwise only
to the point where water begins to flow
out. You will have to repeatedly empty the
collection container every now and then.
6. Completely unscrew the lint trap (27)
once the water stops flowing.
7. Remove all foreign bodies and clean the
lint trap (27) under running water.
8. Replace the lint trap (27) and screw it all
the way in.
9. Fold the shutter (17) back into position.

Emptying residual water

(27)
CAUTION!
Risk of injury!
Improper handling of the appliance
may result in injury.
■ The appliance is very heavy. Nev-
er carry it alone, but always have at
least two persons to do so.
If the appliance is in a frost-prone room, you
must drain the residual water so that it does
not freeze in the appliance and cause damage.
1. Follow steps 1 to 7 as described in
Section „Cleaning the lint trap" (see
page EN-27).
2. With the assistance of another person, tilt
the appliance forward slightly to allow any
residual water to drain from the appliance.
(27)
3. Replace the lint trap and screw it clock-
wise all the way in.
4. Fold the cover (17) back into position.
5. Unscrew the water inlet hose from the
valve and remove the drainage hose from
the tub or siphon to drain any residual
water.