Balluff BOS R254K-UUI-RE10-S4 Konfiguration Seite 137

BOS R254K-UUI-RE10-S4
Photoelectric Sensors
4
Primary Device Functions (continued)
Teach-In Channel
With the help of this parameter, the switching channel that
is to be taught is selected.
Value Meaning
0 Default SSC
1 SSC 1
2 SSC 2
3 SSC 3
4 SSC 4
255 All SSC
Tab. 4-12: Switching profiles – Teach-In Channel
Teach-In Result
Outputs the current status of the currently active or of the
last teach-in process:
Teach-In Flags SP
SP2 SP1
TP2 TP1 TP2 TP1
Bit 7
Tab. 4-13: Switching profiles – Teach-In Result
Bit Meaning Description
position
7 Flag SP2 TP2 0 = Teach point not detected
6 Flag SP2 TP1
5 Flag SP1 TP2
1 = Teach point successfully
4 Flag SP1 TP1
3...0 State 0 = IDLE – No currently
1 = SP1 SUCCESS – Last
2 = SP2 SUCCESS – Last
3 = SP12 SUCCESS – Last
4 = WAIT FOR COMMAND
5 = BUSY – Process active
6 = Reserved
7 = ERROR – Last process
Tab. 4-14: Switching profiles – Teach-In Result
www.balluff.com
Description
Standard / product-
specific SSC (SSC1)
All implemented SSCs
Teach-In State
Bit 0
or not successfully
detected.
detected.
active teach process
process for SP1 was
successful.
process for SP2 was
successful.
process for SP1 and SP2
was successful.
– Wait for next
command.
was not successful.
SSC X Parameter
This parameter represents the currently set switching
points (setpoint 1 and setpoint 2). The switching point 1
(setpoint 1) is active in all switching modes and can be
taught. Switching point 2 (setpoint 2) is only active in
Two-Point or Window Mode and is otherwise deactivated.
If a setpoint is deactivated, it is set to the value
0x7FFFFFFC (No measurement data) and it is also not
possible to change the value.
Moreover, it is possible to deactivate a switching channel
(SSC) in this way. Here, the value 0x7FFFFFFC (No
measurement data) must be set in one of the activated
setpoints.
english 33