JUNO JB136D8 Benutzerinformation Seite 12

12
6. Press . The DURATION time starts
automatically after 5 seconds.
When the set time ends, the signal sounds
for 2 minutes. and time setting flash in
the display. The oven turns off.
7. Press a sensor field or open the oven
door to stop the signal.
8. Turn off the oven.
Setting the END
1. Set an oven function and temperature.
2. Touch again and again until
starts to flash.
3. Use or to set the END and
or to confirm. First you set the
minutes and then the hours.
When the set time ends, an acoustic
signal sounds for 2 minutes.
time setting flash in the display. The
appliance deactivates automatically.
4. Touch a sensor field or open the oven
door to stop the acoustic signal.
5. Turn off the appliance.
Setting the TIME DELAY
function
1. Set an oven function and temperature.
2. Touch again and again until
starts to flash.
3. Use or to set the minutes for
DURATION.
4. Touch .
5. Use or to set the hours for
DURATION.
6. Touch , the appliance switches to
the setting of the END function.
The display shows flashing
7. Use or to set the END and
or to confirm. First you set the
minutes and then the hours.
Appliance turns on automatically later on,
works for the set DURATION time and
stops at the set END time. At the set time
an acoustic signal sounds for 2 minutes.
and the time setting flash in the
display. The appliance deactivates
automatically.
8. Touch a sensor field or open the oven
9. Turn off the appliance.
Setting the SET+GO
You can use the SET+GO function only
when the DURATION is set.
1. Set an oven function (or a programme)
and the
2. Set the DURATION.
3. Touch
4. Touch
The display shows
indicator. This indicator shows which clock
function is activated.
5. Touch a sensor field (apart from ON /
Setting the MINUTE MINDER
1. Touch
and "00" flash in the display.
2. Use
3. Use
.
4. Touch
When the set time ends, an acoustic
signal sounds for 2 minutes and 00:00 and
flash in the display.
5. Touch a sensor field or open the oven
door to stop the acoustic signal.
When the Time delay function
is activated, the display shows
a static symbol of the oven
function, with a dot and
The dot shows which clock
function is on in the Clock /
residual heat display.
and temperature.
again and again until
flashes in the display.
to set the SET+GO function.
OFF) to start the SET+GO function.
.
to switch between options.
First you set the seconds, then the
minutes and the hours.
or to set the MINUTE
MINDER and to confirm.
or the MINUTE MINDER
starts automatically after 5 seconds.
door to stop the acoustic signal.
.
and with an