Technical Characteristics - tau K122M Installationsanleitung

Schalt und steuertafel fuer den getribemotor speed 2

Vorschau ausblenden Andere Handbücher für K122M:

Installationsanleitung (45 Seiten)

Inhalt

Inhaltsverzeichnis

Verfügbare Sprachen

LOGICS WITH MICROPROCESSOR



STATUS OF INPUTS SIGNALLED BY LEDs



"PEDESTRIAN GATE" FUNCTION



INCORPORATED FLASHING CIRCUIT



ENCODER SENSOR FOR OBSTACLE DETECTION AND SELF-LEARNING OF TRAVEL



RECEIVER CONNECTOR



BATTERY AND BATTERY CHARGER CONNECTOR (OPTIONAL)



DIAGNOSTICS OF MALFUNCTIONS SIGNALLED BY LED



When you have completed the connection:

 All the green LS LEDs must be on (each of them corresponds to a Normally Closed input).

The go off only when the controls to which they are associated are operated.

 All the red LS LEDs must be off (each of them corresponds to a Normally Open input). The

light up only when the controls to which they are associated are operated.

Before proceeding, make sure the mechanical components work correctly. Also check

that the gear motor assembly has been installed according to the instructions. Then make

sure that the power consumption of the gear motor is not greater than 3A (otherwise the

control panel may not work properly).

THE EQUIPMENT MUST BE INSTALLED "EXPERTLY" BY QUALIFIED PERSONNEL AS

REQUIRED BY LAW.

NB : it is compulsory to earth the system and to observe the safety regulations that are

in force in each country.

IF THESE ABOVE INSTRUCTIONS ARE NOT FOLLOWED IT COULD PREJUDICE

THE PROPER WORKING ORDER OF THE EQUIPMENT AND CREATE HAZARDOUS

SITUATIONS FOR PEOPLE. FOR THIS REASON THE "MANUFACTURER" DECLINES ALL

RESPONSIBILITY FOR ANY MALFUNCTIONING AND DAMAGES THUS RESULTING.

ATTENTION:

do not use single cables (with one single wire), ex. telephone cables, in order to avoid

breakdowns of the line and false contacts;

do not re-use old pre-existing cables;

we recommend to use the TAU cable code M-03000010C0 to connect the motors to the

control board.

Board power supply

Max motor power DC

Fast acting fuse for protection of input power supply 13.5 Vac (F1 - 5x20)

Fast acting fuse for motor protection (F2 - 5x20)

Fast acting fuse for protection of auxiliary circuits 18 V dc (F3 - 5x20)

Motor power supply circuits voltage

Auxiliary device circuits supply voltage

Logic circuits supply voltages

Operating temperature

CONTROL BOARD FOR SPEED 2 GEARMOTOR