Technical Characteristics - tau K123M Installationsanleitung

CONTROL BOARD FOR MASTER12Q GEARMOTOR
• LOGICS WITH MICROPROCESSOR
• STATUS OF INPUTS SIGNALLED BY LEDs
• "PEDESTRIAN GATE" FUNCTION
• INCORPORATED FLASHING CIRCUIT
• ENCODER SENSOR FOR OBSTACLE DETECTION AND SELF-LEARNING OF TRAVEL
• RECEIVER CONNECTOR
• BATTERY CONNECTOR
• BATTERY CHARGER BOARD (INTEGRATED)
• DIAGNOSTICS OF MALFUNCTIONS SIGNALLED BY LED
TESTING
When you have completed the connection:
• All the green LS LEDs must be on (each of them corresponds to a Normally Closed input).
The go off only when the controls to which they are associated are operated.
• All the red LS LEDs must be off (each of them corresponds to a Normally Open input). The
light up only when the controls to which they are associated are operated.
ATTENTION:
- do not use single cables (with one single wire), ex. telephone cables, in order to avoid
breakdowns of the line and false contacts;
- do not re-use old pre-existing cables<
- we recommend to use the TAU cable code M-03000010C0 to connect the motors to the
control board.

TECHNICAL CHARACTERISTICS

Board power supply
Max motor power DC
Fast acting fuse for protection of input power supply 13.5 Vac (F1 - 5x20)
Fast acting fuse for motor protection (F2 - 5x20)
Fast acting fuse for protection of auxiliary circuits 18 V dc (F3 - 5x20)
Fast acting fuse for protection of battery (F4 - 5x20)
Motor power supply circuits voltage
Auxiliary device circuits supply voltage
Logic circuits supply voltages
Operating temperature
CONNECTIONS TO TERMINAL BOARD
Terminals Function
1 - 2 MOTOR 18V DC motor supply output 18V DC max. 50 W;
3 - 4
5 - 6 PHOTOCELL TX
7 - 8 FLASHING LIGHT
14
Description
auxiliary circuits output 18V DC max. 15 W (3 = NEGATIVE -
AUX
4 = POSITIVE) for photocells, relays, receivers, etc...;
18V DC output for transmitter photocell – phototest - (5 =
NEGATIVE - 6 = POSITIVE) max. no. 1 photocell transmitter;
18V DC max. 20W output for flashing light supply (7 = NEGA-
TIVE - 8 = POSITIVE), flashing signal supplied by the control
unit, rapid for closing, slow for opening;
K123M
13,5V AC - 50 Hz
50 W - 18V DC
F 15A
F 15A
F 1,6A
F 10A
18V DC
18V DC
5V DC
-20 °C ÷ +55 °C