Installing The Front Wheel - ROSE THE BRUCE Bedienungsanleitung

3.5

Installing the front wheel

DANGER
Risk of accident due to improperly fitted quick release axles and threaded axles!
Improperly fitted thru axles might loosen during the ride, which may loosen or block the wheel!
• Only tighten quick release axles by hand and without using any tools.
• Always tighten threaded axles to the required torque.
• If in doubt, please consult the ROSE service or a qualified bicycle mechanic.
Installing the front wheel with Manitou Circus Pro
1. Position the front wheel into the dropouts of the fork.
2. Slide the thru axle through the right dropout of the
suspension fork and the hub of the wheel.
3. Use a 6 mm hex wrench to completely thread the thru axle
into the fork dropout and tighten it to a torque of 9 Nm.
Installing the front wheel with RockShox Pike DJ
1. Remove the thru axle from the fork.
2. Position the front wheel into the dropouts of the fork.
3. Open the lever and slide the axle through the non-drive side
(left in the direction of travel) fork dropouts and hub of the
wheel.
4. Rotate the lever clockwise until there is only a small gap left
between lever head and dropout.
5. Close the lever of the thru axle.
→ There must be no gap between lever head and dropout.
→ The lever should leave an imprint on your hand. To
increase lever tension, open the lever and turn it
clockwise. Close the lever to recheck lever tension.
Repeat until the tension is sufficient, then close the lever.
The axle lever can be adjusted to close anywhere around the axle, so it does not interfere with the frame or any
components. Please see the manual of your RockShox Maxle Ultimate thru axle for instructions.
9 Nm
29