Installing And Adjusting The Handlebar - ROSE THE BRUCE Bedienungsanleitung

3.3

Installing and adjusting the handlebar

DANGER
Risk of accident due to incorrect installation!
Any improperly installed components could loosen during the ride!
• For mounting a stem you need to comply with specific instructions!
• Do not exceed torques!
• Do not use grease or other lubricants to mount the stem.
5 - 6 Nm
A
5 - 6 Nm
A
1. Completely loosen the upper and lower handlebar clamp bolts (B, C) and remove the handlebar clamp.
2. Install handlebar and handlebar clamp and tighten the lower bolts of the handlebar clamp (C) slightly
(max. 1 Nm).
→ The lower gap between handlebar clamp and stem (D) must be completely closed.
3. Align the handlebar.
4. Tighten the upper bolts of the handlebar clamp (B) alternately with a torque wrench until you have reached a
tightening torque of 6 Nm.
Tightening the upper bolts (B) preloads the lower bolts (C) to the intended value. The lower bolts of the handlebar
clamp (C) must not be tightened any further!
5. Check the steering bearing for play by pushing the front wheel against a wall and gently moving the bike
backwards and forwards. Place one hand on the lower cup of the headset and the fork crown.
→ You should not notice any play.
6. If you feel any movement inside the headset, tighten the adjusting screw for the steering play a quarter turn.
7. Check the headset once again for play and repeat the previous steps, if need be, until there is no more play
inside the bearing. If in doubt, seek professional advice from a qualified bicycle mechanic.
8. Tighten the stem clamp bolts (A) alternately to a torque of 5-6 Nm.
6 Nm
B
B
6 Nm
C
C
!
max. 1 Nm
D
!
! max. 1 Nm
27