Adjusting Saddle Height - ROSE THE BRUCE Bedienungsanleitung

3.4

Adjusting saddle height

DANGER
Raising the seat post above the minimum insertion mark may cause accidents or damage!
If the seat post is not inserted to the minimum insertion mark, it may break or damage the frame.
• The seat post must not be extended further than the limit mark!
• When cutting down the seat post, the original minimum insertion mark is no longer valid.
• Make sure to insert the seat post at least 10 cm into the frame.
1. Use a 4 mm hex wrench to open the saddle clamp.
2. Carefully slide the seat post into the seat tube until you have reached the desired height and align the saddle
so it is perfectly straight.
→ The seat post must not be extended further than the limit mark!
→ When cutting down the seat post, the original minimum insertion mark is no longer valid. Make sure to
insert the seat post at least 10 cm into the frame.
→ Stop inserting the seat post when any resistance is felt.
3. Use a 4 mm hex wrench to tighten the seat post clamp to a torque of 6 Nm.
28
4
6 Nm