Stryker Isolibrium PE Bedienungsanleitung Seite 16

O O p p e e r r a a t t i i o o n n
A A p p p p l l y y i i n n g g t t h h e e l l i i n n e e n n s s
W W A A R R N N I I N N G G
• Always follow your hospital CPR protocols. Make sure that the operator has access to the CPR straps.
• Do not use fitted sheets with this support surface.
C C A A U U T T I I O O N N - - Do not stick needles into a support surface through the support surface cover. Holes may allow body fluids to
enter the inside (inner core) of the support surface and could cause cross-contamination, product damage, or product
malfunction.
To apply the linens:
1. Use the D-rings to apply the flat sheet linens.
2. Thread the four linen corners through the D-rings (C) located on the bottom cover. Secure the linens (A) to the support
surface (B).
N N o o t t e e
• Do not pull the linens tight. Keep the linens loose and as smooth as possible on top of the support surface. This is to
effectively use the Turn Assist and Lateral Rotation functions.
• Always make sure that the CPR straps are accessible.
P P o o s s i i t t i i o o n n i i n n g g a a p p a a t t i i e e n n t t o o n n t t h h e e s s u u p p p p o o r r t t s s u u r r f f a a c c e e
W W A A R R N N I I N N G G
• Do not exceed the safe working load of the product.
C C A A U U T T I I O O N N
• Always center the patient on the support surface. Align the patient's head toward the headboard before you start
functions. Check the patient to maintain the proper position.
• Always make sure that the tubes and wires connected to the patient are long enough, stable, and secure while lateral
rotation or turn assist is active.
• Always raise the bed siderails before you start turn assist or lateral rotation functions.
• Do not stick needles into a support surface through the support surface cover. Holes may allow body fluids to enter the
inside (inner core) of the support surface and could cause cross-contamination, product damage, or product
malfunction.
• Do not allow sharp edges from the X-ray plate to come in contact with the support surface cover. The recommendation is
you cover the X-ray plate with a pillowcase or other device before placement under the patient. If damaged, remove the
support surface cover from service immediately to prevent cross contamination.
EN 12
B
F F i i g g u u r r e e 6 6 – – A A p p p p l l y y l l i i n n e e n n s s
A
C
2973-009-005 Rev AE.0