Maintenance / Cleaning - Storch Power HD Krake Bedienungsanleitung

CAUTION
The machine should not be used:
− in areas where there is a risk of explosion and/or to vacuum potentially explosive substances.
− This applies in particular to areas in which machines must be B1 compliant;
− to vacuum dusts that are hazardous to health;
−
to vacuum flammable liquids and acids;
−
to vacuum oily or non-conductive liquids;
−
to vacuum ignition sources;
−
without a filter for vacuum cleaning.
−
CAUTION Electrics:
Never run over, crush or strain the power lead. Check the power lead on the immersion pump and suction unit regularly
for signs of damage. If you detect any damage, do not use the machine. When replacing power or machine connecting
leads, observe the manufacturer's specifications. Couplings on any extension leads you use must be waterproof. Avoid
damaging the pump leads when cleaning the inside of the barrel. Unplug the mains plug before commencing main-
tenance work. When cleaning and maintaining machines, replacing parts, or retooling for a different task, switch the
mains switch to the "0" position and unplug the mains plug. The machine must be operated by trained staff only who
are familiar with safety instructions and have been explicitly instructed to use the machine. Observe the safety and
accident prevent rules that apply on site when using the machine.
The device possesses a voltage range which can pose an electrical hazard to humans and animals. It should only be un-
screwed and / or disassembled by authorised personnel. Similarly, maintenance and repair work should only be conducted
by electrical specialists and authorised service centres. The buyer / user operates the device at their own risk and under
their own responsibility.
If the fuse belonging to the socket used is unknown, the operator of the Power HD Krake must use a safety device with
protective earth conductor monitoring (e.g. PRCD-S article number 60 02 25).

Maintenance / Cleaning:

After use, tip the remaining waste water out of the suction unit barrel. Always flush the barrel with clean water. Remove
stones, paint residue and soiling from the suction inlet on the immersion pump. After cleaning do not connect the barrel
to the suction basket, but allow both parts to dry.
When cleaning, check the machine air filter cartridge below the suction basket for signs of soiling and damage. To ensure
optimum vacuum flow interruption when the filter basket is full, keep the ball in the filter basket, the filter basket itself
and the seal clean.
Flush the cleaning unit thoroughly with clean water after use. Make sure you clean the sealing brushes thoroughly.
Regularly check that the axle on the dirt blaster is securely seated and tighten it clockwise with the assembly bolt included
in the scope of delivery. To do so, position the assembly bolt in the openings provided for this purpose on the axis on the
inside of the cleaning hood.
Maintenance
Basic safety information
Caution: Always disconnect the mains plug from the electric circuit before maintenance!
- The installation and use of spare parts and accessories not sourced from the device manufacturer is pro-
hibited!
- The maintenance intervals must be complied with.
- Changing operating parameters and components is prohibited.
Maintenance schedule
- After each use of the device, check for external visual damage - e.g. housing, cables, suspension, chassis.
- After each use of the device, it must be maintained as described under Maintenance / Cleaning.
- Annual inspection of equipment safety in accordance with DGUV V3 by a qualified person (electrician).
65 Translation of the original instruction