Before Starting The Engine; Stopping The Engine; Working With The Log Splitter - ATIKA ASP 11 N Originalbetriebsanleitung

Transport closure
Oil dipstick
If the hydraulic system is not vented, the trapped air will
damage the seals and cause permanent damage to the log
splitter.
Hydraulics
Never operate the machine in the event of any possible
danger from hydraulic fluid.
Ensure that the machine and working area are clean and
free of oil.
Danger of slippage or fire!
Check the hydraulic reservoir regularly to ensure that it
contains enough hydraulic oil (see "Care and
maintenance").
Capacity: approx. 5.5 litres
Please note the enclosed assembling
sheet!

Before starting the engine

Check the oil and fuel level (refill if required).
Cold start of the engine
1. Put the choke lever (28) to the position
closed.
2. Put the throttle (31) approx. 1/3 toward the position
.
3. Put the fuel valve (22)
4. Put the ignition switch (5) to the position
5. Grasp and slowly pull the cranking rope handle (30)
until you feel a resistance.
6. Pull the cranking rope quickly and then guide it back
slowly.
Do not fully pull out the cranking rope and do not
allow that the rope handle strikes against the engine.
7. Put the choke lever (28)
open as soon as the engine has started.
8. Put the throttle (31) slowly toward the position
.
30
to the position ON.
ON
to the position
Warm start of the engine
1. Put the choke lever (28) to the position
open.
2. Put the throttle (31) approx. 1/3 toward the position
.
3. Put the fuel valve (22)
4. Put the ignition switch (5) to the position
5. Grasp and slowly pull the cranking rope handle (30)
until you feel a resistance.
6. Pull the cranking rope quickly and then guide it back
slowly.
Do not fully pull out the cranking rope and do not
allow that the rope handle strikes against the engine.
7. Put the throttle (31) slowly toward the position
.

Stopping the engine

Put the throttle lever (31) to the position
1.
Put the ignition switch (5) to the position
2.
Put the fuel valve (22)
3.
Do NOT put the choke lever (28)
closed to stop the engine. This may result in
backfire or engine damages.
Stopping the
EMERGENCY
Put the ignition switch (5) to the position
W o r k i n g w i t h t h e
W o r k i n g w i t h t h e
Do not forget!
SAFETY INSTRUCTIONS
Additional
The log splitter may only be operated by a single person.
The machine may only be operated by persons over the
age of 18 years, and who have read and understood
these operating instructions.
Wear protective equipment (safety goggles/mask, gloves,
safety shoes) to protect yourself from possible injury.
Never try to split logs containing nails, wire or other
similar objects.
Already split wood and wood chips create a dangerous
working area. The operator may stumble, slip or fall.
Always keep the working area neat and tidy.
Never place the hands on or near any moving parts of the
machine when it is switched on. Maintain a safe distance
from the log, the ram and the wedge in order to protect
your hands from injury.
The machine should only be used for splitting logs with a
maximum length of 1300 mm.
Check before splitting if the splitting column has
been sufficiently lubricated to allow its trouble-free
retraction and extension.
to the position ON.
ON
OFF.
to the position OFF.
to the position
engine in
.
OFF
l o g s p l i t t e r
l o g s p l i t t e r
.
an