Adjusting The Table Height - ATIKA ASP 8 N-400 Originalbetriebsanleitung

2. Place the log on the log splitter table.
Only split the logs in the direction of the wood fibres.
3. Hold the log tight with the clamping claws.
4. Press both operating handles down simultaneously:
The splitting blade falls down and splits the log.
5. Release the two control handles, the splitting blade returns to
its initial position.
If you only release one control handle, then the splitting
blade remains where it is.
Special instructions for splitting logs:
Preparations:
The logs to be split should be cut to the maximum dimensions.
Ensure also that the logs are cut straight and square.
Place the log properly on the log splitter, so as not to cause any
risk of stumbling or falling to the operator.
Adjusting the stroke height
In case of shorter wood pieces the efficiency can be increased by
shortening the return of the splitting cutter.
1. Place the log on the
splitting table and press
the two control handles to
bring the splitting blade
down to approx. 2 cm
above the log.
2. Release one control handle so that the blade stays in this
position.
3. Switch the machine off and disconnect the power.
4. Release the second control handle.
5. Shorten the return
path at the rod
fitted to the side by
fixing the holding
screw at the
necessary height.

Adjusting the table height

Upper table plate position
for logs up to 500 mm.
Middle table plate position
for logs up to 700 mm.
Lower table plate position
for logs up to 1050 mm.
1. Release the locking bolt.
2. Pull the table out.
3. Use the table in a position that comes close to the log
length and secure it with the locking bolt.
Holding
screw
23