Adjusting The Table Height - ATIKA ASP 10 N 400 Originalbetriebsanleitung

4. Press both operating handles down simultaneously:
The splitting blade falls down and splits the log.
5. Release the two control handles, the splitting blade returns to
its initial position.
If you only release one control handle, then the splitting
blade remains where it is.
Special instructions for splitting logs:
Preparations:
The logs to be split should be cut to the maximum dimensions.
Ensure also that the logs are cut straight and square.
Place the log properly on the log splitter, so as not to cause any
risk of stumbling or falling to the operator.
Adjusting the stroke height
In case of shorter wood pieces the efficiency can be increased by
shortening the return of the splitting cutter.
1. Place the log on the
splitting table and
press the two control
handles to bring the
splitting blade down to
approx. 2 cm above
the log.
2. Release one control handle so that the blade stays in this
position.
3. Switch the machine off and disconnect the power.
4. Release the second control handle.
26
5. Shorten the return
path at the rod
fitted to the side by
fixing the holding
screw at the
necessary height.

Adjusting the table height

Upper table plate position: 590 mm.
Middle table position: 900 mm.
Lower base position: 1300 cm.
1. Split logs up to 590 mm on the table plate.
Secure the table plate using the locking bolt.
(The locking bolt engages in the table plate hole.)
2. Split logs up to 900 mm on the table. Pull out the table
plate.
3. Split logs up to 1300 mm on the base. Press the locking lever
down and swing aside the table.
Locking lever
Holding
screw
Locking bolt
Table plate
Table
Base