Heating Up; Temperature Setting - STORZ & BICKEL Volcano Gebrauchsanweisung

7. V O L C A N O D I G I T
7.1. Commissioning
Do not leave the device unat-
tended during operation. Put
the VOLCANO DIGIT on a flat
and stable surface.
Check whether the mains voltage cor-
responds to the voltage rating stated
on the device. The power cord and the
power plug must be in perfect condi-
tion. Only connect the VOLCANO DIGIT
to a properly installed (grounded)
socket.
It is mandatory to electrically ground
the Hot Air Generator. The manufac-
turer will not bear any responsibility
whatsoever if this accident prevention
measure is not taken.
When the power plug is plugged in,
the LED display of the device lights up
briefly. At the same time, an internal
software query is performed.
The green dot on the display shows
that the Hot Air Generator is connected
to the mains supply.

7.2. Heating Up

To switch on the heater, push the but-
ton labeled "HEAT". The set/actual
temperature will light up, signaling that
the heater is switched on.
At the same time, the yellow control
lamp will light up to indicate that the
device is heating up.
The upper, red display shows the actu-
al temperature in the Filling Chamber
with the air pump switched on, and the
lower, green display shows the desired
set temperature. The heating process
is completed when the set value is
equal to the actual value. The heating
process can take up to 5 minutes de-
pending upon the chosen temperature.
After the heating process is completed,
the temperature is constantly main-
tained at the set value. The luminous
intensity of the yellow control lamp
corresponds to the intensity of the
heating process.
For technical reasons the tem-
perature in the Filling Cham-
ber cannot be measured dur-
ing vaporization. During operation the
temperature is measured at the heat
exchanger. The display indicates the
reference values for the attached Fill-
ing Chamber with the air pump
switched on.
66
7. V O L C A N O D I G I T

7.3. Temperature Setting

Minus Temperature Plus Temperature
Button Button
Actual Temperature Set Temperature
Display (red) Display (green)
When you press the plus button, the
set value is increased, and when you
press the minus button, the set value
is decreased. When you briefly tap on
the plus or minus button, the set values
are increased or decreased respective-
ly in 1-degree increments. If you keep
the plus or minus button pressed, the
set values start running continuously
in the corresponding direction. If you
simultaneously tap on the plus but-
ton and the minus button, the display
changes from degree Celsius to de-
gree Fahrenheit and vice versa.
If the actual value is higher
than the set value, you can
speed up the cool off process
by switching on the air pump.
30 minutes after the last time
a button is pressed, the device
automatically switches off.
As long as the heater has a substantial
amount of residual warmth, the tem-
perature is displayed until it drops be-
low +40°C (+104°F). Then the display
turns off, and the green dot on the dis-
play indicates that the Hot Air Genera-
tor is connected to the mains supply.
67