STORZ & BICKEL Volcano Gebrauchsanweisung Seite 44

10. S O L I D VA LV E
Disassembling the Valve
Undo the Slipring and remove the
Valve Balloon along with the Balloon
Fixation Ring. Insert your index finger
into the open end of the Valve Cylinder.
Push up the Valve Cylinder until you
can unscrew the Valve Cap.
Opening the Slipring
Screw off Valve Cap
Remove the Valve Cap and Valve Ring.
Pull out the Valve Cylinder along with
the Valve Spring of the Valve Housing.
In case of stiffness, the component
parts can be loosened by warming
them up in warm water.
Slipring
Balloon Fixation Ring
Valve Cap
Valve Ring
Valve Housing
Gripper Indentation
Gripper
Valve Spring
Valve Cylinder
Reassemble in reverse order.
86
10. S O L I D VA LV E
Disassembling the Filling Chamber
Insert
The Filling Chamber Insert can be eas-
ily removed from the Filling Chamber.
The Filling Chamber Insert can be dis-
assembled by screwing off the hex nut.
Disassembling the Filling Chamber Insert
Pin
Filling Chamber Disc
Screen Brace Disc
Upper Screen
Washer
Hex Nut (M2)
Reassemble in reverse order.
Disassembling the Filling Chamber
The lower Screen will be pushed out
of the Filling Chamber. The Filling
Chamber Ring can be pulled off with
tweezers.
Pull off Filling Chamber Ring with tweezers
87