Solid Valve; Application And Operation - STORZ & BICKEL Volcano Gebrauchsanweisung

10. S O L I D VA LV E

10.1. Application and Operation

The Balloon Material must be
kept out of the reach of chil-
dren as it is a potential source
of danger. As an alternative to the VOL-
CANO Balloon, only use heat-resistant,
food safe and odor-free oven tubes and
oven bags.
Filling the Filling Chamber
Remove the entire Filling Chamber In-
sert and fill the Chamber with the de-
sired amount of ground plant material.
max. 10 mm
min. 1 mm
Fill Filling Chamber
Fit in the Filling Chamber Insert and
use the pin to lower the Screen Unit so
that the content of the Filling Chamber
is loosely fixed between the Screens.
approx. 1 mm
Insert Filling Chamber Insert
Make sure that the Filling Chamber
Disc sits properly in the Filling Cham-
ber. It must touch the top edge of the
Filling Chamber Cylinder made of
stainless steel.
Take care that the Screens are
not obstructed with plant ma-
terial. To guarantee optimal
results, we recommend to clean the
Screens after each vaporization cycle
with the enclosed Cleaning Brush.
Put the Filling Chamber on the hot air
outlet of the Hot Air Generator. Switch
on the air pump. To do so, press the
green button/switch labeled "AIR". The
Filling Chamber as well as the vapor-
ization material must be preheated for
a couple of seconds before the aromas
and fragrances will start to vaporize.
80
10. S O L I D VA LV E
approx. 5 sec
Preheat plant material for a few seconds
Before putting the Valve Bal-
loon on the Filling Chamber,
stretch it so that it extends ver-
tically from the Hot Air Generator when
it is filled.
Stretch Valve
Balloon tight
81