STORZ & BICKEL Volcano Gebrauchsanweisung Seite 36

9. E A S Y VA LV E
Stretch Valve
Balloon tight
Put the Valve Balloon on the Filling
Chamber and allow it to lock in place.
This will open the Valve. Now the Valve
Balloon will fill with vapor.
Only fill the Valve Balloon with the ap-
proximate amount of vapor that you
intend to use within the next 10 min-
utes. Do not overfill the Valve Balloon
(overpressure) in order to prevent the
loss of vapor. It is important to watch
the vapor density in the Valve Balloon
(see Chapter 5. "Factors influencing
vaporization", page 60).
ok
Watch vapor density
When the Valve Balloon is filled, switch
off the air pump and remove the Valve
Balloon with Filling Chamber. To do so,
hold the Filling Chamber Cap at the
textured grip.
Remove Valve Balloon with Filling Chamber
Caution! Hot surface!
Do not touch any components
of the Filling Chamber (except
at the textured grip) until they
have cooled down after the
Valve Balloon has been filled.
70
9. E A S Y VA LV E
Caution! Hot surface!
Never leave Filling Chamber on VOLCANO
Never leave the Filling Chamber on top
of the hot air outlet of the VOLCANO
as long as the heater is on, except
when filling the Valve Balloon. Non-
observance can lead to an overheated
Filling Chamber, which might burn
one's fingers.
Detach the Valve Balloon from the
Filling Chamber. When you do so, the
Valve is automatically closed so that
the vapors in the Valve Balloon cannot
escape.
Detach Valve Balloon from Filling Chamber
Attach the Mouthpiece to the Valve
and allow it to lock in place.
Attach the Mouthpiece to the Valve Balloon
To inhale, put the Mouthpiece to your
lips and press them lightly against the
Mouthpiece. By doing so, the Valve
opens and the vapors can be inhaled
from the Valve Balloon. As soon as you
remove the pressure from the Mouth-
piece, the Valve automatically closes.
Press Mouthpiece against lips and inhale
slowly and evenly for several seconds
71