Heating Up; Basic Temperature; Booster Temperature - STORZ & BICKEL Mighty Gebrauchsanweisung

6 C O M M I S S I O N I N G A N D O P E R AT I O N
X Insert the plug into the central
opening.
X Put on the upper lid by turning it
clockwise.
X Unscrew the Filling Aid from the
Vaporizer by turning it 90° counter-
clockwise.
X Put the lower lid on the Filling Aid
by turning it counterclockwise.
X Put the Cooling Unit on the Vapor-
izer by turning it 90° clockwise.
6.7 Heating Up
The Vaporizer provides two tempera-
ture levels that are set in the factory:
The basic temperature at 180°C
(356°F) and the booster temperature
at 195°C (383°F).
X If a particular temperature level is
no longer sufficient, change to the
next level as described below.
6.7.1 Basic Temperature
X Press the orange ON/OFF switch
for at least half a second.
The Vaporizer responds with a
i
short vibration. The display signals
that heating is in progress by show-
ing the set and actual tempera-
tures.
Heating up the heat exchanger can
i
take up to two minutes, depending
on the set temperature and battery
charge level. Once the set tempera-
ture is reached, this is signaled by a
short double vibration.
6.7.2 Booster Temperature
X Activate the booster temperature
by double-clicking the orange ON/
OFF switch.
Once the booster temperature is
i
reached, this is signaled by a short
double vibration and a blinking Set
Temperature display.
Booster mode ends automatically
i
90 seconds after the booster tem-
perature has been reached; the set
temperature is then the basic tem-
perature again.
51