Stiga BC 625 Serie Gebrauchsanweisung Seite 174

5.7 DISPLAY (IF AVAILABLE)
The display (Fig. 19.J) shows
information regarding the machine
operation and maintenance.
Tachometer.
The digits on the display show
the number of engine rpm.
Timer.
The digits on the display show
the machine's hours (H) and
minutes (M) of operation.
Maintenance.
Icon
maintenance is required.
Icon
when the maintenance hourly
threshold is reached.
The frequency and types of
maintenance are summarised
in the "Maintenance Table"
(see chapter 13).
The flashing continues for 1 hour.
6. USING THE MACHINE
IMPORTANT The safety regulations
to follow are described in chap. 2. Strictly
comply with these instructions to avoid
serious risks or hazards.
IMPORTANT The machine
is supplied without fuel.
6.1 PRELIMINARY OPERATIONS
Before using the machine:
1. place the machine in a stable horizontal
position on the ground;
2. choose the most suitable cutting means for
the job to be done (par. 4.3);
3. fill up with fuel. For information about how
to prepare the fuel blend, methods and
precautions for refuelling, see sections 7.2 and
7.3;
4. wear the harness correctly (see section 6.1.1).
6.1.1 Using the harness
The straps must be adjusted in accordance with
the height and build of the operator.
indicates that no
starts to flash
• Single strap models
The harness must be worn before securing the
machine to the attachment.
The strap (Fig. 20.A) must pass over the left
shoulder, towards the right side.
The strap must be worn with:
– the support (Fig. 20.A.1), the machine's snap
hook (Fig.20.A.2). and the quick release
hook (Fig. 20.A.3) on the right side.
• Double strap models
The harness must be worn before securing the
machine to the attachment.
The strap (Fig. 20.B) must be worn with:
– the support (Fig. 20.B.1), the machine's
carbine hook
release (Fig. 20.B.3) located on the right
side;
– the quick release at the front (Fig. 20.B.4);
– the strap crossover on the back of the
operator (Fig. 20.B.6);
– the buckles correctly fastened (Fig.
The straps must be tightened so that they
distribute the load evenly over the shoulders.
IMPORTANT In case of danger, unhook the
machine using the quick release (Fig. 20.B.3).
• Models with backpack
The backpack must be put on after turning on the
machine.
The backpack (Fig. 20.C) must be worn with:
– the shoulder straps on the operator's
shoulders (Fig. 20.C.1);
– the buckles correctly fastened (Fig. 20.C.2).
– the machine's carbine hook located on the
right side (Fig. 20.C.3);
– the quick release at the front (Fig. 20.C.4);
The straps must be tightened so that they
distribute the load evenly over the shoulders.
IMPORTANT In case of danger, unhook the
harness using the quick release (Fig. 20.C.4).
6.2 SAFETY CHECKS
Run the following safety checks and ensure that
the results correspond to those outlined in the
tables.
Always carry out the safety checks before
use.
EN - 10
(Fig. 20.B.2) and the quick
20.B.5).