Changing The Battery Of The Purion Display - Urban Arrow Family Gebrauchsanweisung

2
The Kiox display can be removed during the charging
procedure or fitted after the charging procedure has started.
Each continuously lit LED on the charge-control indicator 56 is
equivalent to a charge capacity of approx. 20 %. A flashing LED
indicates the charging of the next 20 %. Once the e-bike battery
is fully charged, the LEDs extinguish immediately and the display
(in case mounted) is switched off. The charging procedure is
terminated.
After charging
The procedure after the charging procedure is terminated is as
follows:
1. Disconnect the charger from the main power supply.
2. Disconnect the battery from the charger. The battery
automatically switches off.
3. If you have charged the battery while placed in the battery
holder on the bike, carefully close the charge socket with the
cover so no dirt or water can get into the charge socket.
2
Once the battery is charged it will switch off. If the charger
is not disconnected from the battery after charging, after
a few hours the charger will switch itself back on, check
the charging state of the battery and begin the charging
procedure again if necessary.
48 Urban Arrow Family
7.3

Changing the battery of the Purion display

The Purion display is supplied with voltage by two CR 2016 button
cells. When the display shows the text 'low bat' the two batteries
need to be replaced. Changing the batteries is done as follows:
1. Unscrew the fastening screw 101 of the display.
2. Remove the display from the handlebar 86.
3. Open the battery compartment cover 99 by using a coin and
turning it counter clockwise (see image 33).
4. Remove the used battery and insert two new CR 2016
batteries.
2
Mind that the polarity of the battery is correct when inserting
the new battery.
5. Close the battery compartment cover by using a coin and
turning it clockwise.
6. Place the display back on the handlebar and fasten it with the
fastening screw.