Panasonic AV-HS04M7D Bedienungsanleitung Seite 9

Updating the AV-HS450 software version
 When the [F3] switch is held down, the filename is displayed for the "LoadFile Exec ↓ "
item.
 Turn [F4] to select "V1TOV2.45D".
SDCard 1 | Mode↓ | Select | LoadFile

File | Load| FMEM1|
 All the letters in the filename are displayed in upper-case.
 When the [F5] switch is pressed, the AV-HS450 starts loading the data.
Note
It takes several minutes for all the data to be loaded.
While the data is being loaded, do not turn off the power of the AV-HS450.
Also, while the data is being loaded, do not eject the SD memory card.
 When the data has been loaded, the "Upgrade Completed" message appears.
 Turn off the power of the AV-HS450 (both its control panel and main frame), and then
turn it back on again.
2. Loading the version update file
 Press the [SYSTEM] button to light its indicator, and display the SYSTEM menu.
 Turn [F1] to display the MainVer sub menu.
<Menu display>
13 | Select | Version |
SYS

MainVer |MFSoft | |
 Check that "V1TOV2" is displayed for the SysVer item.
 Press the [SDCard] button to light its indicator, and display the SDCard menu.
 Turn [F1] to display the File sub menu.
 Turn [F2] to select "Load" for the Mode item, and press the [F2] switch.
<Menu display>
SDCard 1 | Mode↓ | Select | LoadFile

File | Load| FMEM1|
Exec↓
V1TOV2.45D
|
SysVer
|
V1TOV2
Exec↓
No
15 (E)
Updating the AV-HS450 software version
 When the [F3] switch is held down, the filename is displayed for the "LoadFile Exec ↓ "
item.
 Turn [F4] to select "V2.45D".
SDCard 1 | Mode↓ | Select | LoadFile

File | Load| FMEM1|
 All the letters in the filename are displayed in upper-case.
 When the [F5] switch is pressed, the AV-HS450 starts loading the data.
Note
It will take several minutes for all the data to be loaded.
While the data is being loaded, do not turn off the power of the AV-HS450.
Also, while the data is being loaded, do not eject the SD memory card.
 When the data has been loaded, the "Upgrade Completed" message appears.
 Turn off the power of the AV-HS450 (both control panel and main frame), and then
turn it back on again.
5. Checking the AV-HS450 version upgrade
Take the steps described in "1. Checking the AV-HS450 software version" above, and
check that the AV-HS450 software version is "2.00.00" or higher.
Exec↓

V2 .45D
16 (E)