Mounting - Panasonic AV-HS04M7D Bedienungsanleitung

Mounting

Mount the board in the AV-HS450 main frame.
Notes
 This board will not work if the software version of the AV-HS450 is below "2.00.00".
Before mounting the board, refer to "Updating the AV-HS450 software version".
 Be sure to ask the dealer where you purchased the product for assistance with
mounting and removal.
 Turn off the power and unplug the power connector before mounting and
removal.
 Before making any physical contact with the board, touch your hand to metal that
has been grounded to discharge static electricity from your body.
An anti-static wrist strap is recommended for safety. Failures may be caused if
you touch this board while you are still charged with static electricity.
 Avoid damage to this board by not dropping it or subjecting it to strong shocks or
vibrations.
 Be sure to mount the blank panel installed, after removing this board.
 When installing or removing this board, take care not to hurt yourself on the
edges and metal parts of the boards.
 Turn off the power of the AV-HS450, and unplug the power cord.
 Loosen the two screws of SLOT B at the rear of the AV-HS450, and remove the blank
panel.
SLOT A
SLOT B
Blank panel
Screw
Screw
17 (E)
Mounting
 Align the board with the guide rails, and insert it slowly.
Insert it all the way in. Take care not to use force to insert the board because the
connector inside the AV-HS450 may be damaged in the process.
 Attach the board using the two screws.
Clamping torque: 0.7 N•m
 After connecting the necessary cables, plug in the power cord, and turn on the power.
Note
This board must be mounted in SLOT B of the AV-HS450 (main frame).
It will not work if it is mounted in SLOT A.
T
OU
UT S
TP
I OU
SD
3D
Screw
T
OU
Screw
18 (E)