Panasonic AV-HS04M7D Bedienungsanleitung Seite 13

Operation (3D mode)
3D mode overview
Adjusting the 3D video input
 Refer to "Setting the input signals".
 The input video signals can be reversed or moved
horizontally or vertically.
(Only standard SDI input signals INPUT1 to 16 are
supported.)
 When the keystone function is enabled, the size of the
input video signals can be adjusted and the signals can
be rotated in addition to moving them horizontally and
vertically.
(One set of inputs for the Lch and Rch signals each
is supported. When the keystone function has been
enabled, PinP composition cannot be performed.)
Selecting the 3D video signals
 Refer to "Setting the crosspoints".
 The Lch and Rch signals can be assigned to one XPT
button and selected at the same time.
Six 3D video output formats available
 Refer to "Setting the output signals".
 Any of the following 3D output formats can be selected:
Simul (L, R)
Side by side
Line by line
LR mixed (2 types)
LR difference display
LR check display
3D video signal status monitor displays
 Refer to "3D video signal status monitor displays".
 On the sub picture of the multi-view display, histograms
of the Lch and Rch signal components (luminance, R, G
and B) can be displayed or the amount of parallax in the
3D images can be displayed as histograms.
It is also possible to display a grid for visually checking
the amount of parallax.
Switching between the 2D mode and
3D mode
The 2D mode or 3D mode can be selected using the
SYSTEM menu.
Notes
 The 3D mode cannot be selected unless the board has
been mounted in the AV-HS450.
 The 2D mode setup data and 3D mode setup data are
not interchangeable.
 When switching between the 2D mode and 3D mode, all
the settings stored in the AV-HS450 will be initialized.
Before switching the mode, save the setup data on an
SD memory card.
 Refer to "3-12-2. Saving data on SD memory cards"
in the operating instructions of the AV-HS450.
 Press the [SYSTEM] button to light its indicator, and
display the SYSTEM menu.
 Refer to "2-1-5. LCD menu area" in the operating
instructions of the AV-HS450.
 Turn [F1] to display the 3DFormat sub menu.
<Menu display>
2 | Mode↓
SYS
3DFormat| 
An asterisk () appears on the left of the currently
selected mode.
 Turn [F2] to select the video mode (2D or 3D) for the
Mode item, and press the [F2] switch.
 Turn off the power of the AV-HS450 (both its control
panel and main frame), and then turn it back on again.
22 (E)
| | |
2D| | |
3D